Classic BattleTech Miniatures: IWM 20-367 MWDA Spider
|
|
|
|
Classic BattleTech Miniatures: IWM 20-367 MWDA Spider |
|
|
|
|
|
|
|
 |
|||
 |
11 pieces total: Torso Left/Right Arm Backpack Two different chin weapons Two mandible pieces for the torso Two claw pieces for the arms Waist with Legs |
 |
 |
|
 |
Step #1: Epoxy the Backpack to the torso. I used putty to level the torso while the epoxy cured. | |
|
Step #2: Use putty to set the torso on its back and epoxy one of the two supplied chin weapons to the torso. |  |
|
|
 |
Step #3: Epoxy the forearm claws to the arms using the tabs and slots provided on the pieces. The arm claws have the 2 spikes at the rear of the claw. | |
|
Step #4: After the chin weapon epoxy sets a bit, you can add the mandible pieces to the torso. Make sure the chin weapon is set enough that it wont get knocked off the torso. The epoxy should be thick enough to hold the mandible pieces in place while it cures. |  |
|
|
 |
Step #5: Epoxy the arms to the torso using putty to support the pieces. | |
|
Step #6: Epoxy the torso to the waist/leg piece. The pieces should not require putty to support them. |  |
|
 |
|||
Purchase the mini shown above now 
Return to the Assembly Guide Menu - ERH Home - Continue shopping - Join the forum
Report a problem with this page to admin@exodus-road.com